Pro-Ject Debut Carbon EVO (2020)

The Debut Carbon EVO is an entry-audiophile turntable built around an 8.6-inch carbon-fibre tonearm and a factory-fitted Sumiko Rainier MM cartridge. Its rear panel offers a fixed MM phono-level RCA output with a dedicated ground lug — no built-in preamp and no line-level switch, so the receiver or amplifier side must provide phono input or an external phono stage. A separate 15V DC wall-wart feeds the motor via a small barrel jack and keeps mains noise out of the signal path. Replacement ground wires and low-capacitance Connect It E phono cables are the only accessories most owners ever need.

Belt-drive turntable with fixed MM-phono RCA output, dedicated ground terminal, and external 15V DC wall-adapter power.

Device Information

Manufacturer
Pro-Ject
Release Year
2020
Model Number
Debut Carbon EVO
Category
Turntable

Available Ports

Connector Quantity Power (PD) Capabilities Label Notes
RCA Stereo Audio 1 — — Phono Output (L/R, rear) Gold-plated female RCA sockets carrying a cartridge-level MM phono signal. Requires phono input or external phono preamp on the receiver side.

This device is not in the Cable Finder yet. Browse cables by the ports it has:

Other Pro-Ject Turntable models with the same ports

Same ports, other brands

Notes & Compatibility

Signal output is phono-level only — the Debut Carbon EVO has NO built-in phono preamp and NO phono/line switch (unlike the AT-LP120XUSB / SL-1500C), so it must connect to a phono input or an external phono stage. Ships with a semi-balanced Pro-Ject Connect It E RCA phono cable and a separate ground wire. Powered by an external 15V DC 0.8A wall-wart into a small barrel jack on the rear; that power input and the ground screw post aren’t listed in the port table. Speed is changed electronically with a rocker switch under the plinth (33/45/78 RPM), so there’s no belt to move by hand. Outside the US it ships with an Ortofon 2M Red MM cartridge instead of the Sumiko Rainier.

Cablebabe Goes Disco